Free D-PEMX-DY-23 braindumps download (D-PEMX-DY-23 exam dumps Free Updated Jun 07, 2025)
D-PEMX-DY-23 Dumps for Pass Guaranteed - Pass D-PEMX-DY-23 Exam 2025
NEW QUESTION # 41
Which three components store an MX7000 chassis service tag and MAC address configuration?
(Select 3)
- A. LCD Panel
- B. Fabric Switching Engine
- C. Chassis Luggage Tag
- D. Management Module
- E. Right Control Panel
Answer: A,D,E
NEW QUESTION # 42
Which two actions are possible using the Chassis Deployment Wizard?
(Select 2)
- A. The LCD pin can be configured.
- B. The firmware catalog can be configured using the FTP protocol.
- C. The administrator can use an existing chassis profile to configure the chassis.
- D. The network I/O Module password can be configured.
Answer: B,C
NEW QUESTION # 43
When performing "A1 the Box" management, what must be done to successfully connect to the Management Module?
- A. Attach standard A-to-A USB cable to a laptop
- B. Change the baud rate to 128000
- C. Configure PuTTY for a serial connection
- D. Connect cables to the KVM
Answer: C
NEW QUESTION # 44
An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI.
What is the likely cause of this issue?
- A. iDRAC Express license is installed
- B. Installed OS is not supported
- C. OS and iDRAC are configured on different networks
- D. OS to iDRAC pass-through feature is not enabled in the iDRAC
Answer: D
NEW QUESTION # 45
What is the port configuration of an MX5108n switch?
- A. 8 x internal 25GbE ports
1 x 40GbE QSFP+ port
2 x 100GbE QSFP28 ports
4 x 10GbE RJ45 Base-T ports - B. 8 x internal 25GbE ports
2 x 40GbE QSFP+ ports
1 x 100GbE QSFP28 port
4 x 10GbE RJ45 Base-T ports - C. 16 x internal 25GbE ports
4 x 40GbE QSFP+ ports
2 x 100GbE QSFP28 ports
1 x 10GbE RJ45 Base-T port - D. 16 x internal 25GbE ports
1 x 40GbE QSFP+ port
2 x 100GbE QSFP28 ports
4 x 10GbE RJ45 Base-T ports
Answer: A
NEW QUESTION # 46
An administrator has been tasked with specifying hardware for a deployment having the following requirements:
4 node cluster within a single MX7000 chassis
Each node needs a minimum of 6x 2.5" drives
3 TB of memory and 64 physical CPU cores per node
What is the maximum hardware configuration that meets the requirements?
- A. MX740c with no storage sleds
- B. MX840c with no storage sleds
- C. MX 840c with MX5016s storage sleds
- D. MX740c with MX5016s storage sleds
Answer: C
NEW QUESTION # 47
What is the benefit of C22 power inlet connectors on the MX7000 chassis?
- A. Enable linking together power supplies
- B. C22 connectors are now standard on PowerEdge
- C. Allow for higher exhaust temperatures
- D. Meet higher power requirements
Answer: C
NEW QUESTION # 48
Which command(s) is supported in the current PowerEdge MX Redfish implementation?
- A. HEAD and PUT
- B. GET and DELETE
- C. PUT and DELETE
- D. PUT only
Answer: B
NEW QUESTION # 49
An administrator is connecting two MX840c to an MX5016s. The MX5016s is configured in Enclosure Assigned mode.
What should the requirements of this mode be to avoid configuration issues?
- A. HBA330MMZ with no OS restrictions
- B. HBA330MMZ with a cluster aware OS
- C. MX745P with a cluster aware OS
- D. MX745P with no OS restrictions
Answer: B
NEW QUESTION # 50
A server administrator wants to configure RAID on drives that are assigned to a compute sled.
Which interface can be used to complete the task?
- A. RAID Controller settings
- B. OIDC
- C. Storage sled assignment
- D. iDRAC
Answer: D
NEW QUESTION # 51
Which statement describes L2 Multicast as implemented on the PowerEdge MX7000 IOM?
- A. MLD snooping and IGMP control or limit the flooding of IPv4 multicast traffic on VLANs.
- B. MLD snooping controls the flooding of IPv6 multicast traffic on VLANs while the IGMP limits the flooding of IPv4 multicast traffic.
- C. MLD snooping controls the flooding of IPv4 multicast traffic on VLANs while the IGMP limits the flooding of IPv6 multicast traffic.
- D. MLD snooping and IGMP control or limit the flooding of IPv6 multicast traffic on VLANs.
Answer: B
NEW QUESTION # 52
An administrator is mapping the drives of an MX5016s. The disk must be split in groups among multiple compute sled slots.
Which storage configuration must be used?
- A. Drive-Assigned mode
- B. Split-Assigned mode
- C. Enclosure-Assigned mode
Answer: A
NEW QUESTION # 53
A PowerEdge MX7000 chassis was ordered with a factory-generated password. The customer needs to reset the PowerEdge MX7000 chassis configuration using the RACADM racresetcfg command.
What login credentials will the customer need to use to log on after running the command?
- A. root / calvin
- B. admin / password found on luggage tag
- C. root / password found on luggage tag
- D. admin / calvin
Answer: C
NEW QUESTION # 54
A systems administrator must extract log files from an MX7000. The logs cannot be saved locally and must only be stored on a secure file server.
Which share protocols can they use to save the logs?
- A. HTTPS and SCP
- B. CIFS and NFS
- C. SFTP and CIFS
- D. HTTPS and SFTP
- E. NFS and HTTPS
Answer: B
NEW QUESTION # 55
Refer to the exhibit.
A customer recently replaced all the dual-port network cards in mezzanine A with quad-port network cards across all 16 PowerEdge MX740c sleds in the two-chassis configuration. The customer can only access half of the network ports, even though the quad-port cards are visible in the iDRAC.
What actions are required to resolve the problem?
- A. Install a new 200G cable from port 3 on the MX7116n in chassis 2 slot A1 into port 19 on the MX9116n in chassis 1 slot A1.
Do the same for the switches in slots A2.
Adjust the switch configuration to use the new ports. - B. Reseat all the switches.
Adjust the switch configuration to use the new ports. - C. Reboot the switches.
Adjust the switch configuration to use the new ports. - D. Do a virtual reseat of all the MX740c sleds.
Update the firmware on all the quad port network cards.
Adjust the switch configuration to use the new ports.
Answer: A
NEW QUESTION # 56
......
Verified D-PEMX-DY-23 dumps Q&As - Pass Guarantee Exam Dumps Test Engine: https://www.exams4sures.com/EMC/D-PEMX-DY-23-practice-exam-dumps.html