Changing the Concept of D-PDD-DY-23 Exam Preparation 2024 [Q16-Q37]

Share

Changing the Concept of D-PDD-DY-23 Exam Preparation 2024

Getting D-PDD-DY-23 Certification Made Easy! Get professional help from our D-PDD-DY-23 Dumps PDF

NEW QUESTION # 16
What is a characteristic of Dell Cloud Tier?

  • A. Scales to the maximum capacity of the active tier
  • B. NFS, HTTPS, and CIFS are supported for data movement
  • C. The VTL vault cannot be stored in cloud tier storage
  • D. Managed through a single namespace

Answer: D


NEW QUESTION # 17
A backup administrator needs to add capacity to a file system. After the installation of an ES40, they need to verify the total amount of data stored before data reduction.
Which command would be used to verify this information?

  • A. enclosure show summary
  • B. filesys show summary
  • C. filesys show space
  • D. filesys status

Answer: C


NEW QUESTION # 18
What is a key differentiator of Dell PowerProtect DD systems in terms of data handling during the write process?

  • A. Data is encrypted after it is written to disk.
  • B. Data is stored in its original format without any optimization.
  • C. Data is deduplicated and encrypted inline as it is written to disk.
  • D. Data is deduplicated after it is written to disk.

Answer: C


NEW QUESTION # 19
A PowerProtect DD with two ES40 expansion shelves was just installed. An error message is received.
What is the most likely reason?

  • A. The host port on the expansion shelf connects upstream to the controller
  • B. The expansion port on the last shelf connects back to the controller
  • C. The expansion port on the shelf connects downstream to the host port of the next shelf
  • D. The controller HBA port connects to the host port of an expansion shelf

Answer: B


NEW QUESTION # 20
Where can the serial number on a PowerProtect DD appliance be found?

  • A. Label on the top of the chassis
  • B. Right side of the chassis
  • C. Label attached to the bezel
  • D. PSNT tag at the rear of the system

Answer: D


NEW QUESTION # 21
An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?

  • A. Use larger tapes for multiple smaller datasets
  • B. Set retention periods for as long as possible
  • C. Use multiple drives to write multiple streams
  • D. Target multiple drives to write single stream

Answer: C


NEW QUESTION # 22
Which backup application can back up data to a PowerProtect DD system using DD Boost over FC?

  • A. Dell NetWorker
  • B. IBM Spectrum Protect
  • C. Veritas Backup Exec
  • D. Dell Avamar

Answer: A


NEW QUESTION # 23
A customer has stored the data that is in the cloud using PowerProtect DD. For security reasons, encryption will be applied to the data.
What is the required action to achieve the customer's goal?

  • A. Encrypt and reupload the data
  • B. Turn off encryption and reenable
  • C. Enable the encryption via cloud tier level
  • D. Activate the Data at Rest encryption

Answer: A


NEW QUESTION # 24
When selecting a PowerProtect DD model, which standard practices should be used to conservatively calculate capacity and throughput?

  • A. Capacity: First full backup + Incremental backups + (Weekly cycle * Number of weeks data is retained) Throughput: Size of largest backup / Backup window time Allow for a minimum 20% buffer in both capacity and throughput
  • B. Capacity: First full backup + First incremental backup + (Weekly cycle * Number of weeks data is retained) Throughput: Size of average backup / Backup window time Allow for a minimum 10% buffer in both capacity and throughput
  • C. Capacity: First full backup + Incremental backups + (Weekly cycle * Number of weeks data is retained) Throughput: Size of largest backup / Backup window time Allow for a minimum 10% buffer in both capacity and throughput
  • D. Capacity: First full backup + First incremental backup + (Weekly cycle * Number of weeks data is retained) Throughput: Size of average backup / Backup window time Allow for a minimum 20% buffer in both capacity and throughput

Answer: A


NEW QUESTION # 25
What needs to be configured when implementing LACP on a PowerProtect DD appliance to gain access to the underlying aggregated link connection?

  • A. NIC Teams
  • B. DD Boost Interface Groups
  • C. Physical network interface
  • D. Virtual network interface

Answer: D


NEW QUESTION # 26
A systems administrator wants to change encryption.
Which user role is needed to log in, and what command must be run to enable the security policy?

  • A. security officer user and run authorization policy set security-officer enabled
  • B. security officer user and run authentication policy set security-officer enabled
  • C. sysadmin user and run authorization policy set security-officer enabled
  • D. sysadmin user and run authentication policy set security-officer enabled

Answer: A


NEW QUESTION # 27
What is a requirement to use the PowerProtect DD HA feature?

  • A. Head units and nodes require an active/active configuration
  • B. Dual set of shared storage configuration
  • C. Each head unit requires its own FS25 shelf
  • D. A single set of shared storage

Answer: B


NEW QUESTION # 28
Which PowerProtect DD feature can be used if the existing backup solution is designed using a tape-based logic?

  • A. BoostFS
  • B. DD Boost
  • C. DD Retention Lock
  • D. DD VTL

Answer: D


NEW QUESTION # 29
What are the settings for serial communication when connecting to a PowerProtect DD appliance?

  • A. 115200, 8, 1, none, Xon/Xoff, and vt-100
  • B. 57600, 8, 1, none, Xon/Xoff, and vt-100
  • C. 57600, 8, 1, none, none, and vt-100
  • D. 115200, 8, 1, none, none, and vt-100

Answer: D


NEW QUESTION # 30
An administrator notices that several disks on a shelf show as unknown.
What should be done to resolve this issue?

  • A. Ensure the expansion shelf is cabled properly
  • B. Cycle the power on the newly added expansion shelf
  • C. Enter the storage add enclosure command
  • D. Enter the disk unfail command for the unknown disks

Answer: D


NEW QUESTION # 31
A company is using Amazon Web Services as a cloud provider and needs to create a cloud unit.
Which certificate must be imported to the PowerProtect DD appliance?

  • A. Dell EMC Root certificate
  • B. Digicert High Assurance Root CA certificate
  • C. AWS Root CA certificate
  • D. Baltimore CyberTrust Root CA certificate

Answer: D


NEW QUESTION # 32
An administrator is configuring an AWS S3 cloud unit on their DD9400.
Which certificate must be imported before adding the cloud unit?

  • A. S3 Flexible
  • B. GlobalSign Root R1
  • C. Baltimore CyberTrust Root CA
  • D. GlobalSign Root R2

Answer: C


NEW QUESTION # 33
Which enterprise applications does the DDBEA agent support?

  • A. SAP with Oracle, IBM DB2, and Microsoft active directory
  • B. Oracle, Microsoft Sharepoint, and Microsoft SQL
  • C. Microsoft SQL, Sharepoint, and Exchange servers
  • D. IBM DB2, Microsoft SQL, and SAP HANA

Answer: D


NEW QUESTION # 34
A PowerProtect DD appliance with two expansion shelves is being installed in a customer-provided rack.
When cabling the controller to the shelves, what is connected to the host port on the last shelf in the chain?

  • A. Host port of the downstream shelf
  • B. Expansion port of the upstream shelf
  • C. Expansion port of the controller
  • D. Host port of the controller

Answer: B


NEW QUESTION # 35
Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?

  • A. SSL
  • B. HTTPS
  • C. FTP
  • D. SSH

Answer: B


NEW QUESTION # 36
What can be used to monitor system utilization?

  • A. Health tab in the System Manager GUI
  • B. system show performance command
  • C. system status command
  • D. Alert Messages

Answer: D


NEW QUESTION # 37
......

D-PDD-DY-23 Exam Crack Test Engine Dumps Training With 165 Questions: https://www.exams4sures.com/EMC/D-PDD-DY-23-practice-exam-dumps.html